← Fixing Stalled Package Manager in pfSense 2.4.I’m currently leveraging the DNS method so I don’t plan on testing this out right now, but please leave a comment if this works for you or not. OPNsense does have the option for IP address or host so I would be interested in knowing whether or not using the unconverted IP address works for people. In pfSense or OPNsense go to your DHCP server and add it to the Additional Options section Convert the IP address of the controller to hex then prepend it with 01:04, replacing all periods with colons (.) to (:)ġ92.168.1.1 would look like 01:04:c0:a8:01:01 I haven’t tried this option yet but it’s listed in the documentation. This works for layer 3 adoption which is useful when you are working across different subnets. Once you’ve ssh’d into the device run the command set-inform The Unifi device should show up after this. You can get the SSH username and password (or if you’re more secure, the keys) by going to settings –> Site and at the bottom Device Authentication In this scenario you can change the IP address of your controller first, then ssh into each device and run the ‘set inform’ command to provide them with the new IP address of the controller. If you have enabled the changes but some of your devices did not re-provision with the new changes, you can SSH into your device and run set-inform Fix: Option 2 – SSH set-inform It may not happen instantly as it depends on when your switch/aps poll again. Once it has, log back in and wait for the devices to reconnect. Change your static DHCP assignment or however you manage your IP addresses and wait for the controller to move over to the new IP address. Now, log into whatever device manages your DNS and create a static entry for unifi. They will now seek that entry rather than that it was using before. Save and allow the devices to re-provision. Under the Controller Hostname/IP specify a hostname of unifi., replacing with whatever it is you are using (potentially. Fix: Option 1 – It’s DNSīefore changing your controller’s IP address, log into your controller and navigate to settings–>controller Setting the Ubiquiti UniFi Inform URL via SSH SSH into each Access Point. Whatever the reason, making this change will cause any adopted devices to show up disconnected and they will not be able to reach the controller. PicClick Insights - Ubiquiti UniFi WiFi 6 Pro Access Point U6-Pro-US THIS. Perhaps you don’t like the DCHP lease IP address it has or you want to move it to a management VLAN. There may come a time when you want to change the IP Address of your controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |